The attribute values and their import is as described below: Possible values for this attributes can be obtained with the command as shown below:Īs seen in the above screen shot, DCPP provides more attribute values apart from default ones as facilitated by BIOS F2. DCPP presents this feature to the user in the form of attribute named ‘WakeOnLAN’ ‘LAN or WLAN’ – Allow the system to be powered on by special LAN or wireless LAN signals.ĭell Command PowerShell Provider(DCPP) has strived hard to present this feature to the user closely adhereing to F2 screen as possible. ‘WLAN Only’ – Allow the system to be powered on by special WLAN signals. ‘LAN Only’ – Allow the system to be powered on by special LAN signals. ‘Disabled’ – Does not allow the system to power on by special LAN signals when it receives a wakeup signal from the LAN or wireless LAN. The import of the above attribute values are explained below: In case the computer being awakened is communicating via Wi-Fi, a supplementary standard called Wake on Wireless LAN must be employed.īelow shows the screen shot of BIOS F2 screen which facilitates Wake on LAN/WLAN:Īs seen in the screen above BIOS F2 provides 4 options ‘Disabled’,’LAN Only’, ‘WLAN Only’ and ‘LAN or WLAN’. If a magic packet is received that is directed to the device's MAC address, the NIC signals the computer's power supply or motherboard to initiate system wake-up, much in the same way as pressing the power button would do. Powered-down or turned off computers capable of Wake-on-LAN will contain network devices able to "listen" to incoming packets in low-power mode while the system is powered down. Wake-on-LAN is implemented using a specially designed packet called a magic packet, which is sent to all computers in a network, among them the computer to be woken up. Ethernet connections, including home and work networks, wireless data networks and the Internet itself, are based on packets of data sent between computers. This feature only works when the computer is connected to AC. Wake on LAN/WLAN option allows the computer to power up from the S4 or S5 state when triggered by a special LAN signal or when triggered by a special wireless LAN signal.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |